Envirotex Lite High-Gloss Epoxy Coating

EX-88 is a crystal-clear, ultra-durable, high-gloss epoxy designed to deliver a deep, glass-like finish in just one layer when applied to a properly sealed surface. Perfect for projects that require a professional-grade, waterproof, and heat-resistant coating.

Key Features

✅ Waterproof Protection
Creates a strong, moisture-resistant barrier for long-lasting durability.

✅ Heat Resistant
Holds up under heat exposure without compromising strength or clarity.

✅ Self-Leveling Formula
Effortlessly spreads into a smooth, even surface for a flawless finish.

✅ Extended Working Time
25-minute open time at 70°F gives you plenty of time to work before it begins to set.

✅ Bubble Release Technology
Formulated to release bubbles naturally when poured immediately after mixing.

Usage Guidelines

• Working Time (Open Time):
  You’ll have approximately 25 minutes to work with EX-88 at 70°F.
  Tip: Warmer temperatures will shorten this window, so pour immediately after mixing.

• Surface Preparation:
  Always seal your surface before application to improve adhesion, prevent air bubbles, and ensure a crystal-clear finish.

• Pouring Technique:
  Pour right after mixing for the best self-leveling effect and maximum bubble release.

Frequently Asked Questions

Q: How do I prevent bubbles?
🫧 Pour the epoxy immediately after mixing. You can also use a torch or heat gun to pop any stubborn surface bubbles.

Q: Can EX-88 be used for deep pours?
⚡ No — EX-88 is designed for surface coatings only. For thicker projects, use a deep-pour epoxy.

Q: How long does EX-88 take to cure?
⏲️ Cure times vary depending on temperature and humidity, but it typically fully cures within 24–72 hours.

Q: What are the best storage conditions?
❄️ Store resin in a cool, dark place (60°F–75°F / 15°C–24°C), away from sunlight and moisture.
Pro Tip: Wipe container tops before sealing to prevent stuck caps.

Q: What environment is best for pouring?
☀️ Work in a ventilated, temperature-controlled area with humidity below 60% to avoid cloudiness and bubbles.
To protect your cured project from yellowing or warping, keep it out of direct sunlight. For extra UV protection, consider using Amazing Clear Cast Plus.